printf("-a Use AWGN channel and not multipath\n");
printf("-c Number of PDCCH symbols\n");
printf("-m MCS1 for TB 1\n");
printf("-M MCS2 for TB 2\n");
printf("-d Transmit the DCI and compute its error statistics\n");
printf("-p Use extended prefix mode\n");
printf("-n Number of frames to simulate\n");
printf("-o Sample offset for receiver\n");
printf("-s Starting SNR, runs from SNR to SNR+%.1fdB in steps of %.1fdB. If n_frames is 1 then just SNR is simulated and MATLAB/OCTAVE output is generated\n",snr_int,snr_step);
printf("-f step size of SNR, default value is 1.\n");
printf("-C cell id\n");
printf("-S subframe\n");
printf("-D use TDD mode\n");
printf("-b TDD config\n");
printf("-B bandwidth configuration (in number of ressource blocks): 6, 25, 50, 100\n");
printf("-r ressource block allocation (see section 7.1.6.3 in 36.213\n");
printf("-g [A:M] Use 3GPP 25.814 SCM-A/B/C/D('A','B','C','D') or 36-101 EPA('E'), EVA ('F'),ETU('G') models (ignores delay spread and Ricean factor), Rayghleigh8 ('H'), Rayleigh1('I'), Rayleigh1_corr('J'), Rayleigh1_anticorr ('K'), Rice8('L'), Rice1('M')\n");
printf("-F forgetting factor (0 new channel every trial, 1 channel constant\n");
printf("-x Transmission mode (1,2,6,7 for the moment)\n");
printf("-q Number of TX antennas ports used in eNB\n");
printf("-y Number of TX antennas used in eNB\n");
printf("-z Number of RX antennas used in UE\n");
printf("-t MCS of interfering UE\n");
printf("-R Number of HARQ rounds (fixed)\n");
printf("-A Turns on calibration mode for abstraction.\n");
printf("-N Determines the number of Channel Realizations in Abstraction mode. Default value is 1. \n");
printf("-O Set the percenatge of effective rate to testbench the modem performance (typically 30 and 70, range 1-100) \n");
printf("-I Input filename for TrCH data (binary)\n");
printf("-u Enables the Interference Aware Receiver for TM5 (default is normal receiver)\n");
exit(1);
break;
}
}
set_parallel_conf("PARALLEL_RU_L1_TRX_SPLIT");
set_worker_conf("WORKER_ENABLE");
if(transmission_mode>1)pa=dBm3;
printf("dlsim: tmode %d, pa %d\n",transmission_mode,pa);
...
...
@@ -1481,7 +1845,7 @@ int main(int argc, char **argv) {
