1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
#!/bin/bash
#/*
# * Licensed to the OpenAirInterface (OAI) Software Alliance under one or more
# * contributor license agreements. See the NOTICE file distributed with
# * this work for additional information regarding copyright ownership.
# * The OpenAirInterface Software Alliance licenses this file to You under
# * the OAI Public License, Version 1.1 (the "License"); you may not use this file
# * except in compliance with the License.
# * You may obtain a copy of the License at
# *
# * http://www.openairinterface.org/?page_id=698
# *
# * Unless required by applicable law or agreed to in writing, software
# * distributed under the License is distributed on an "AS IS" BASIS,
# * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# * See the License for the specific language governing permissions and
# * limitations under the License.
# *-------------------------------------------------------------------------------
# * For more information about the OpenAirInterface (OAI) Software Alliance:
# * contact@openairinterface.org
# */
# file init_nas_nos1
# brief loads the nasmesh module and sets up the radio bearers (used to provide ip interface without S1 interface)
# author Florian Kaltenberger
#
#######################################
load_module()
{
mod_name=${1##*/}
mod_name=${mod_name%.*}
if awk "/$mod_name/ {found=1 ;exit} END {if (found!=1) exit 1}" /proc/modules
then
echo "module $mod_name already loaded: I remove it first"
sudo rmmod $mod_name
fi
echo loading $mod_name
sudo insmod $1
}
function main()
{
PCI=`lspci -m | grep Xilinx`
if [ -z "$PCI" ]; then
echo "No card found. Stopping!"
return
fi
## This part corrects the wrong configuration of the endpoint done by the bios in some machines
echo "$PCI" | while read config_reg; do
SLOT_NUMBER=`echo $config_reg | awk -F\" '{print $1}'`
sudo setpci -s $SLOT_NUMBER 60.b=10
done
load_module $OPENAIR_DIR/targets/bin/openair_rf.ko
sleep 1
if [ ! -e /dev/openair0 ]; then
sudo mknod /dev/openair0 c 127 0
sudo chmod a+rw /dev/openair0
fi
$OPENAIR_DIR/targets/bin/updatefw -s 0x43fffff0 -b -f $OPENAIR_TARGETS/ARCH/EXMIMO/USERSPACE/OAI_FW_INIT/sdr_expressmimo2_v10
}
main "$@"